Set pressa a occhielli occhielli standard

Misura

• Size denotes eyelet and tool size together: inner diameter of standard eyelet, matching eyelet tool and matching hole punch are combined in the same size step.
• Choose size by planned hole, desired eyelet inner dimension and visible edge; change size only as a complete variant.

Colour

• Colour describes the visible surface effect of the chosen eyelets and helps optical matching to fittings, fabric and leather.

Eyelet material

• Steel: Our zinc-plated steel eyelets are the most economical choice for simple, decorative or less durable applications.
• Brass: Brass is rust-free, easily formed and proven for eyelets when function and appearance matter equally.
• Stainless steel: Stainless steel is the most robust and durable option — rust-free, uncoated and naturally silver.

Press

• The press determines force, handling and expandability. Lighter pressa a levas suit many standard eyelets; very hard packages, large snap fastener blanks over 23 mm or DIN 7332 eyelets often require a more powerful pressa a ginocchio or pressa a percussione a molla.
• Which presses are selectable results exclusively from variant configuration.

Which variant fits your project?

• Light textiles, bags, labels and typical reinforcements benefit from smaller to medium eyelet sizes.
• Outdoor and damp applications favour rust-free variants; warm brass tones suit classic leather and canvas looks.

Preparation and processing

• Back thinner fabrics, keep multi-layer areas flat and ensure clean hole guidance.
• Press calmly and straight; if stubborn, check material stack, tool use and chosen size before pressing again.

Workflow

1. Install hole punch and brass anvil in the press.
2. Position workpiece flat on anvil and punch all holes where an eyelet will sit.
3. Remove fabric residue from the punch tube.
4. Screw upper eyelet tool part into press and tighten with pliers.
5. Insert lower tool part into 12 mm holder.
6. Check both tools are clean and undamaged.
7. Place eyelet with shaft up in lower tool part.
8. Guide punched hole of workpiece over shaft of inserted eyelet.
9. Place washer over shaft and workpiece.
10. Press eyelet preferably in one stroke.
11. If eyelet is loose, repeat pressing.

With Getmore Crafts products

• In your chosen variant press, hole punch, eyelet tool and eyelets are matched.
• Tools and presses in this set use 1/4"-20 UNC thread and 12 mm lower holder, allowing exchange of other tools with same thread and/or holder.
• Depending on press, thread and holder can be converted — see respective product page.
• Tool in this set is not for DIN eyelets. You can buy tool separately but need a spring-strike or toggle press.

With products from other manufacturers

• This set is designed for Getmore standard eyelets and included tool; function with eyelets or tools from other manufacturers cannot be guaranteed.

Your package contains

• 1 press
• 1 hole punch
• 1 eyelet tool
• 100 eyelets

Press-specific additional content

• Accessories such as hex keys, nuts, centring aids or mounting material may vary or be missing depending on chosen press; check included scope before first use if needed.

Technical details